Rear Seat

The cushion and squab heaters are regulated by in-line thermostats and operated by switches mounted on the central console switch pack. Operation of a switch causes a timer circuit to energize the heater supply (for 11 minute ±1). The supply will remain on until timed out, although the heater circuit will be broken by the thermostat if the set temperature is exceeded.


NOTE: Heating can only occur when the ignition switch is position II and the ambient temperature is below the thermostat pre-set value of 26 °C.

Rear Seat Adjustment System, Fig.1:

1. Central rear seat switch console
2. RH Seat assembly
3. Rear seat control module (RSCM)
4. LH Seat assembly

Seat Component Locations, Fig.1:

1. Lumbar pad
2. Squab heater
3. Lumbar pump
4. Seat harness to link connector
5. Fore/aft motor
6. Cushion heater connector
7. Headrest motor
8. Squab frame attachment bracket