Feed Pipe to Fuel Rail

- Depressurize the fuel system. Fuel Pressure Release
- Disconnect the battery earth lead.
- Displace the fuel feed hose from the fuel rail securing clips.

Fuel Feed Hose To Fuel Rail:

- Undo the fuel feed to fuel rail union nut and reposition the hose from the rail.
- Fit protective plugs to the fuel rail and the hose.
- Release the hose to inlet manifold retaining clip and reposition from the clip.

Legris Hose Connector:

- Release the hose to fuel feed pipe quick-fit connector by pulling back on the connector collar.
- Remove the hose from the fuel feed pipe.
- Fit protective plugs to the hose and the fuel feed pipe.
- Fitting a new hose is the reversal of the removal procedure.

CAUTION: Pipes and component stubs must be fully inserted into connector ends to ensure proper fit; failure to do so could cause fuel leakage.

Note: There are two sizes of connector and pipe, 8mm and 10mm, this is to ensure that the feed pipe is not connected as the return pipe and vice versa. The 10mm connector/pipe is used for the feed line.