Throttle Cable/Linkage: Service and Repair
THROTTLE CABLERENEW
Disconnect battery earth lead. Disconnect electrical connectors from kickdown switch. (1).
Slacken locknut and disconnect throttle cable from pulley. (2).
Disconnect cable assembly from bulkhead tube. (3).
Remove and discard split pin securing throttle cable to throttle pedal, pull off sleeve and release cable from pedal. (4).
Pull cable through to engine compartment.
NOTE: On right-hand drive cars the cable is secured to the bulkhead by a nut above the driver's footwell.
Release cable from pedestal.
Slacken throttle cable locknut at pedestal bracket, remove throttle cable assembly.
Examine bulkhead grommet for damage, renew as necessary. Fit grommet to cable.
Refitting is the reversal of the above operations, apply suitable sealing compound around cable and grommet at bulkhead (right-hand drive cars).
Check throttle linkage adjustment. Check kickdown switch adjustment. Re-connect battery earth lead.