Inspection and Adjustment

TRANSMISSION ASSEMBLY

Inspection and Adjustment


INSPECTION AFTER INSTALLATION

Check A/T Fluid Leakage
Check A/T position after adjusting A/T positions. A/T Position.
Equipotential Test
After installing transmission assembly, measure resistance below.
- Between transmission (aluminum part) and body (ground bolt)
- Between transmission (aluminum part) and electric compressor (aluminum part).

WARNING:


To prevent electric shock hazards, be sure to put on insulating protective gear before beginning work on the high voltage system.
Standard: Less than 0.1 Ohm
If result deviates from standard values, check that no paint, oil, dirt, or other substance is adhering to bolts or conductive mounting parts. If any such substance is adhering, clean the surrounding area and remove the substance.

ADJUSTMENT AFTER INSTALLATION

- Adjust A/T fluid level. Adjustment.
- Adjust A/T position. A/T Position.
- Perform "CLUTCH 1 POSITION LEARNING". Description.
- Perform "ADDITIONAL SERVICE WHEN REPLACE TRANSMISSION ASSEMBLY". Description.