Inspection Procedure

ACTION TEST

Inspection Procedure


CAUTION:
To prevent the possibility of accident, be careful of traffic conditions and safety around the vehicle when performing road test.
NOTE:
- Fully understand the following items well before the road test;
- Precautions: Precaution For LDW/LDP System Service.
- System description for LDW: System Description.
- System description for LDP: System Description.
- Handling precaution: Precautions For Lane Departure Warning/Lane Departure Prevention.

1. CHECK LDW SYSTEM SETTING

1.Set the vehicle to READY.
2.Check that the LDW system setting can be enabled/disabled on the navigation screen.
3.Turn OFF the ignition switch and wait for 30 seconds or more.
4.Check that the previous setting is saved when the vehicle is set in the READY state again.
- GO TO 2.

2. ACTION TEST FOR LDW

1.Enable the setting of the LDW system on the navigation screen.
2.Turn warning systems switch ON (warning systems ON indicator is ON).
NOTE:
LDP system is OFF.
3.Check the LDW operation according to the following table.





NOTE:
After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 60 km/h (40 MPH). System Description.
- GO TO 3.

3. CHECK LDP SYSTEM SETTING

1.Set the vehicle to READY.
2.Check that the LDP system setting can be enabled/disabled on the navigation screen.
3.Turn OFF the ignition switch and wait for 30 seconds or more.
4.Check that the previous setting is saved when the vehicle is set in the READY state again.
- GO TO 4.

4. ACTION TEST FOR LDP

1.Enable the setting of the LDP system on the navigation screen.
2.Turn dynamic driver assistance switch ON (LDP ON indicator lamp is ON).
NOTE:
LDW system is OFF.
3.Check the LDP operation according to the following table.






NOTE:
After the operating conditions are satisfied, the control continues until the vehicle speed reaches approximately 60 km/h (40 MPH). System Description.
- INSPECTION END