Diagnosis Procedure

TILT&TELESCOPIC SENSOR


Diagnosis Procedure

1.CHECK TILT AND TELESCOPIC SENSOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect tilt and telescopic sensor and automatic drive positioner control unit connector.
3. Check continuity between tilt and telescopic sensor and automatic drive positioner control unit.





4. Check continuity between tilt and telescopic sensor and ground.





Is the inspection result normal?
YES - GO TO 2.
NO - Repair or replace circuit.
2.CHECK TILT AND TELESCOPIC SENSOR POWER SUPPLY
1. Connect automatic drive positioner control unit connector.
2. Check voltage between automatic drive positioner control unit and ground.





Is the inspection result normal?
YES - GO TO 3.
NO - Replace automatic drive positioner. Removal and Installation.
3.CHECK TILT AND TELESCOPIC SENSOR GROUND
Check continuity between automatic drive positioner control unit and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Replace automatic drive positioner. Removal and Installation.
4.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Intermittent Incident.
- INSPECTION END