Adjustment

DOOR


REAR DOOR : Adjustment


CLEARANCE, SURFACE HEIGHT AND SURFACE MISMATCH ADJUSTMENT










1. Check the clearance and surface height and surface mismatch between the rear door and each part visually and by touching. (Fitting standard dimension in the table below should be satisfied.)





Surface
Portion Clearance Surface height mismatch
-1.5 � 1.5 mm
Front door sash molding �
G -- --
(-0.059 � 0.059 in)
Rear door weather-strip
-1.5 � 1.5 mm -1.5 � 1.5 mm
Front door outside molding �
H --
(-0.059 � 0.059 in) (-0.059 � 0.059 in)
Rear door outside molding
2. In case out of specification, adjust them according to the procedures shown below.
3. Remove the center pillar upper garnish and center pillar lower garnish. Removal and Installation.
4. Loosen the hinge mounting nuts on door side.
5. Adjust the surface height and surface mismatch of the rear door according to the fitting standard dimension.
6. Temporarily tighten the hinge mounting nuts on door side.
7. Loosen the hinge mounting nuts and bolts on body side.
8. Raise the rear door at rear end to adjust clearance of the rear door according to the fitting standard dimension.
9. After adjustment tighten bolts and nuts to the specified torque.
10. Install the center pillar upper garnish and center pillar lower garnish. Removal and Installation.

STRIKER ADJUSTMENT





Adjust the striker so that it becomes parallel with the lock insertion direction.