Removal and Installation

REAR DOOR GLASS AND REGULATOR


Removal and Installation












DOOR GLASS

Removal
1. Remove the rear door finisher. Door Finisher Service and Repair.
2. Remove the rear door sash cover inner. Door Finisher.





3. Remove the rear door inner frame.





4. Remove the fixing bolt and pull up the outer corner cover (1) to remove outward.





5. Remove the rear door sash fixing nut and the door side TORX bolt (1).
6. Remove the harness clip and pull out the rear door sash from the door panel.





7. Operate the power window switch to raise/lower the door window until the glass mounting bolts can be seen.
8. Remove the glass mounting bolts.
9. Remove the door glass from the inside of door panel.
10. Remove the door glass run.

Installation
Install in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1. Remove the rear door finisher. Door Finisher Service and Repair.





2. Remove the rear door inner frame.





3. Operate the power window switch to raise/lower the door window until the glass mounting bolts can be seen.
4. Remove the glass mounting bolts.





5. Raise up the door glass and hold with a suction lifter A.
6. Disconnect the connector for the regulator assembly.





7. Remove the regulator mounting bolts, and remove the regulator from the door panel.

Installation
Install in the reverse order of removal.

Inspection after Removal
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Gear wear
- Regulator deformation
- Grease condition for each sliding part





The arrows in the figure show the application points of the multi-purpose grease.