Only Front Wiper Low Does Not Operate

FRONT WIPER AND WASHER SYSTEM


Only Front Wiper Low Does Not Operate

1.ACTIVE TEST
With CONSULT-III
1. Select "FRONT WIPER" of IPDM E/R active test item.
2. With operating the test item, check that front wiper LO operation.
Without CONSULT-III
Start up auto active test. Refer to Auto Active Test.
Does front wiper operate normally?
YES - Refer to Component Tests and General Diagnostics.
NO - GO TO 2.
2.CHECK IPDM E/R
With CONSULT-III
1. Select "FRONT WIPER" of IPDM E/R active test item.





2. With operating the test item, check voltage between IPDM E/R harness connector and ground.





Without CONSULT-III
1. Start up auto active test. Refer to Auto Active Test.
2. Check voltage between IPDM E/R harness connector and ground.





OK or NG
OK - GO TO 3.
NG - Replace IPDM E/R. Refer to Service and Repair.
3.CHECK CIRCUIT BETWEEN IPDM E/R AND FRONT WIPER MOTOR
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector and front wiper motor connector.





3. Check continuity between IPDM E/R harness connector (A) and front wiper motor harness connector (B).





4. Check continuity between IPDM E/R harness connector (A) and ground.





OK or NG
OK - GO TO 4.
NG - Repair harness or connector.
4.CHECK FRONT WIPER REVERSE RELAY
1. Remove front wiper reverse relay.





2. Check continuity between front wiper reverse relay terminals.





OK or NG
OK - GO TO 5.
NG - Replace front wiper reverse relay.
5.CHECK CIRCUIT BETWEEN FRONT WIPER REVERSE RELAY AND GROUND





Check continuity between front wiper reverse relay harness connector and ground.





OK or NG
OK - Replace front wiper motor. Refer to Service and Repair.
NG - Repair harness or connector.