Disassembly and Assembly

FRONT SEAT


Disassembly and Assembly


SEATBACK

Disassembly
1. Remove seatback trim and seatback pad.

NOTE:
Seatback trim and seatback pad can be removed without removing seatback assembly from seat body.





- Remove the retainer from the lower side of seatback board.
- Disconnect the clips and pawls, and then remove the seatback board.
: Pawl
: Clip
- Remove the seatback hinge mounting bolts.





- Remove the retainer on the back side of the seatback.
- Remove the seat speaker grills. (Applied 5.1 ch BOSE studio surround� system models.) Refer to Without Mobile Entertainment System.





- Remove the headrest holder.

CAUTION:
Before installing headrest holder, check its orientation (front/rear and right/left).
- Disconnect the clip, and then remove the reclining device cover.





- Remove the screws, and then remove the seatback upper finisher.
- Remove the bracket mounting nuts.
- Remove seatback trim and pad from seatback frame.
- Remove the hog rings to separate the trim and pad.
2. Remove seatback frame.
- Remove seat speaker. (Applied 5.1 ch BOSE studio surround� system models) Refer to Without Mobile Entertainment System.
- Remove the bands, and then remove seatback thermal electrical device (TED) assembly.
- Remove the seat harness assembly from seatback assembly.
- Remove the bolts, and then remove seatback frame from seat cushion frame.

Assembly
Assemble in the reverse order of disassembly. Be careful of the following one point.





Install the hog rings of seat cushion trim in position, and then securely connect the trim or trim code with the pad side wire.

SEAT CUSHION

Disassembly
1. Remove the seatback trim and seatback pad.





- Remove the retainer from the lower side of seatback board.
- Disconnect the clip and pawl, and then remove seatback board.
: Pawl
: Clip





- Remove the screws and disconnect the clips, and then remove the seat cushion rear finisher. (Climate controlled seat model)
- Remove the seat cushion front finisher.





: Pawl
: Clip





- Remove the seat reclining switch knob and seat slide switch knob.
- Pull seat cushion outer finisher forward, and then disconnect the pawls and clips.





: Pawl
: Clip
- Lift the rear part of the seat cushion outer finisher backward, and then remove the seat cushion outer finisher.
- Remove the harness connector clamp of lumber support switch.
- Removal the lumber support switch.





- Remove the seat cushion inner finisher.
: Pawl
- Remove the retainers from the lower side of front seat. (Driver's seat only)
- Remove the hog rings to separate the trim and pad. (Driver's seat only)
2. Remove the nuts, and then remove the seat cushion frame. (Driver's seat only)
3. Remove each unit which is attached to seat cushion frame and seat adjuster assembly.
- Remove the screws, and then remove the climate controlled seat control unit.
- Remove the screws, and then remove the blower motor.
- Remove the bands, and then remove the seat cushion thermal electrical device (TED) assembly.
- Remove driver's seat control unit. (Driver's seat only)





- Remove the driver seat control switch.
- Remove seat cushion finisher B and seat cushion finisher C.
- Remove seat harnesses.

Assembly
Assemble in the reverse order of disassembly. Be careful of the following two points.





- Install the hog rings of seat cushion trim in position, and then securely connect the trim or trim code with the pad side wire.
- Clamp the harness in position.

CLIMATE CONTROLLED SEAT

Blower Filter Replacement
Put your hand behind front seat cushion, pull filter downward and remove it. Replace filter with a new one.






NOTE:
- When replacing, be sure to set the front seat lifter to the top position.
- When installing, do not confuse up-down direction of the filter.