Removal and Replacement

Control Device Removal and Installation

CONTROL DEVICE COMPONENTS

AT-199 COMPONENTS:

REMOVAL

CAUTION: Make sure that parking brake is applied before removal/installation.

1. Disconnect lower lever of control device and control rod.
2. Move selector lever to "N" position.





3. Remove knob cover (1) below selector lever downward.
4. Pull lock pin (3) out of selector lever knob (2).
5. Remove selector lever knob.
6. Remove cup holder, switch finisher, cluster lid C and A/T console finisher.
7. Remove center console.
8. Disconnect A/T device harness connector.
9. Move selector lever to "P" position.
10. Move driver side seat to the end.





11. Remove one of floor carpet attachment clips (1).
12. Remove control device assembly mounting dolts.





13. Lift control device assembly (1). Then slide to the right till touching floor carpet.





14. Pull control device assembly out in the right-slanting direction while pressing to the right.

INSTALLATION
Note the following, and install in the reverse order of removal.





NOTE: Bend control device assembly (1) to vehicle, then insert lower lever (2) to the rear of vehicle.

^ After installation is completed, adjust and check A/T position. Refer to AT-202, "Adjustment of A/T Position". Adjustments