Rear Door Lock

REAR DOOR LOCK

Component Structure

BL-178 Component:

Removal and Installation

REMOVAL
1. Remove the rear door finisher.




2. Disconnect the inside handle knob cable and lock knob cable from the back side of the rear door finisher.
3. Remove the rear door sash.
4. Remove the rear door window and rear door screen assembly.
5. Remove door side grommet, and remove outside handle escutcheon bolt from grommet hole.






CAUTION: Do not forcibly remove the TORX bolts.




6. While pulling the outside handle, remove outside handle escutcheon.




7. Slide toward rear of vehicle, and pull forward to remove the outside handle.




8. Remove the front gasket and rear gasket.




9. Remove the TORX bolts, remove the door lock assembly.




10. Remove the TORX bolt, and remove the outside handle bracket.




11. While pulling outside handle, slide toward rear of vehicle to remove outside handle.
12. Disconnect the door lock actuator connector and remove the door lock assembly.




13. Reach to separate outside handle cable connection.

INSTALLATION
Install in the reverse order of removal.

CAUTION: To install each rod, be sure to rotate the rod holder until a click is felt.