Removal and Replacement

Control Device Removal and Installation

CONTROL DEVICE COMPONENTS

AT-198 COMPONENTS:

REMOVAL

CAUTION: Make sure that parking brake is applied before removal/installation.

1. Move selector lever to "N" position.





2. Remove knob cover (1) below selector lever downward.
3. Pull lock pin (3) out of selector lever knob (2).
4. Remove selector lever knob.
5. Remove cup holder, switch finisher, cluster lid C and A/T console finisher.
6. Remove center console.
7. Disconnect A/T device harness connector.
8. Remove control device assembly.

INSTALLATION
Note the following, and install in the reverse order of removal.
^ After installation is completed, adjust and check A/T position. Refer to AT-202, "Adjustment of A/T Position". Adjustments