Tightening Torque and Sequence

Rod Bearing Cap
Tighten connecting rod bolt as follows:

Apply engine oil to the threads and seats of connecting rod bolts.
Tighten connecting rod bolts.
Tightening torque 19.6 Nm (2.0 kg-m, 14 ft-lb)
Then tighten all connecting rod bolts 90 degrees clockwise (angle tightening).





CAUTION: Always use the angle wrench [SST: KV10112100 (BT8653-A)]. Avoid tightening based on visual check alone.

After tightening connecting rod bolts, check that crankshaft rotates smoothly.
Check the connecting rod side clearance.

CONNECTING ROD BOLT OUTER DIAMETER





Measure the outer diameter "d" at position shown in the figure.
If the reduction appears in a position other than "d", regard it as "d".
Standard 7.90 - 8.00 mm (0.3110 - 0.3150 in)
Limit 7.75 mm (0.3051 in)
When "d" exceeds the limit (when it becomes thinner), replace connecting rod bolt with new one.