Front Seat

FRONT SEAT

Driver's Seat Component

SE-142 Component - Part 1:

SE-142 Component - Part 2:

Passenger's Seat Component

SE-144 Component - Part 1:

SE-144 Component - Part 2:

Removal and Installation


CAUTION: When removing and installing, use shop cloths to protect parts from damage.

REMOVAL




1. Pull rear leg cover backward while opening outside to remove the rear leg cover.
2. Remove the mounting bolts on the back side of the front seat.




3. Pull rear leg cover forward while opening outside to remove the front leg cover.
4. Remove the mounting bolts on the front side of the front seat.
5. Disconnect harness connector under the seat and remove harness securing clips.

CAUTION: Before removal, be sure to turn ignition switch OFF, disconnect both battery cables, and then wait for at least 3 minutes.

6. Set seatback in a standing position.
7. Remove the headrest.
8. Remove seat from the vehicle.

CAUTION: When removing and installing, use shop cloths to protect parts from damage.

INSTALLATION
Install in the reverse order of removal. Be careful of the following two points.
- Before installation, be sure to turn ignition switch OFF, disconnect both battery cables, and then wait for at least 3 minutes.




- Clamp the harness in position.

CLIMATE CONTROLLED SEAT

Blower Filter Replacement




Put your hand behind front seat cushion, pull filter downward and remove it. Replace filter with a new one.

NOTE:
- When replacing, be sure to set the front seat lifter to the top position.
- When installing, do not confuse up-down direction of the filter.