Removal and Replacement

FRONT REGULATOR

Exploded View

GW-19 Exploded View:

Removal and Installation

REMOVAL
1. Remove front door finisher.
2. Disconnect front door speaker harness connector.




3. Operate the power window main switch to raise or lower the door window until the glass mounting bolts can be seen.
4. Remove the glass mounting bolts.




5. Hold securely the door glass and pull it out of the sash to remove the door glass.

NOTE: Do not raise the glass at the top upper of the door after the door glass has been removed.




6. Disconnect power window motor harness connector (A).




7. Remove the module assembly bolts, both seal (B) and then remove the bolts under the seal.
8. Remove the module assembly from the door panel.

INSTALLATION
Install in the reverse order of removal.