Seals and Gaskets: Service and Repair

Removal and Installation

REMOVAL
1. Remove propeller shaft assembly.





2. Remove rear oil seal using a puller [SST: KV381054S0 (J-34286)].

INSTALLATION





1. Apply multi-purpose grease to lip of rear oil seal (1). Drive in rear oil seal to rear extension using the drift (A) [SST: ST33400001 (J-26082)].
Dimension "H": 1.2 - 2.2 mm (0.047 - 0.087 in)

CAUTION:
^ Never reuse rear oil seal.
^ When installing, never incline rear oil seal.

2. Install propeller shaft assembly.

CAUTION:
^ If lubricant leak has occurred during the repair work, check oil level after finishing work. Refer to TM-16, "Inspection". Inspection