Disassembly and Assembly

DISASSEMBLY AND ASSEMBLY

FUEL LEVEL SENSOR UNIT, FUEL FILTER AND FUEL PUMP ASSEMBLY

Exploded View

FL-13 Exploded View:

Disassembly

CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.

Remove fuel level sensor unit as follows:




1. Disconnect harness connector (A).
- Hold connector by fingers and pull it out, because there is no stopper release tab.




2. Using suitable tool, pull up tabs points as shown in the figure (two points) to release the lock.
1: Fuel level sensor unit
A: Pull up tabs

CAUTION: Be careful not to damage it.




3. After fixing tabs are disengaged, slide fuel level sensor unit (1) out in direction shown by the arrow.
A : Pull

CAUTION: Never disassemble fuel filter and fuel pump assembly.

Assembly

CAUTION: Sub fuel level sensor unit cannot be disassembled and should be replaced as a unit.

1. Check for damage of fuel level sensor unit installation position on the side of fuel filter and fuel pump assembly.
2. Slide fuel level sensor unit until it aligns to installation groove, then insert it until it stops.
- After inserting, apply force in reverse direction (removal direction) to ensure it cannot be pulled out.




3. Connect the black (A) and white (B) harnesses so that they are in the positions shown in the figure.
- Securely insert harness connector until it stops.