Sliding Switch

SLIDING SWITCH

SEATBACK

SEATBACK : Removal and Installation

REMOVAL

CAUTION: When removing and installing, use shop cloths to protect parts from damage.




1. Remove seat back pad.
2. Remove screws (A).
3. Disconnect seat sliding switch (seat back) connector.
4. Remove seat sliding switch (seat back) (2) from seat back frame (1).

INSTALLATION
Install in the reverse order of removal.

CAUTION: Be sure to clamp the harness to the right place.

NOTE: After installing the driver seat, perform additional service when removing battery negative terminal. Refer to SE-7, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement". Testing and Inspection