Console: Service and Repair

CENTER CONSOLE ASSEMBLY

Exploded View

CENTER CONSOLE (A/T MODELS)

IP-23 Exploded View:

CENTER CONSOLE (M/T MODELS)

IP-24 Exploded View:

Removal and Installation

REMOVAL
1. Put selector lever in drive position (A/T models only).
2. Remove selector lever knob (A/T models only).
3. Remove shift lever knob (M/T models only).
4. Remove console finisher.






- Remove clips from rear of console finisher (1), and then remove pawl of front.
- Pull console finisher (1) upward to disengage from center console.
- Disconnect harness connectors.




5. Remove screws (B) of center console front side with screw driver (A).




6. Remove rear upper console assembly (A/T models only).
- Slide to front, pull up rear upper console assembly (1), and disconnect metal clips.
- Disconnect heated seat switch harness connectors. (with heated seat)




7. Disconnect auxiliary input jacks connector (A) and power socket harness connector (B) (A/T models only).




8. Disconnect console sub harness connectors (A) (M/T models only).




9. Disconnect heated seat switch connector (A) (M/T models with heated seat only).




10. Remove coin pocket fixing pawl using a remover tool (A), and then remove coin pocket (1) (M/T models only).




11. Insert a deep-well socket wrench (A) to rotate adjusting nut to loosen cable sufficiently (M/T models only).
Refer to PB-8, "LEVER TYPE: Adjustment".




12. Remove console rear finisher.
- Pull back the console rear finisher (1).
- Disconnect inside key antenna connector (A).

13. Remove console mask.





- Open the console lid.
- Pull up console mask (1) by using a remover tool (C), and disengage pawls.

14. Remove screws (C) of center console rear side, and then remove center console assembly (1).






INSTALLATION
Install in the reverse order of removal.

Disassembly and Assembly

DISASSEMBLY AND ASSEMBLY OF CENTER CONSOLE (A/T MODELS)

Disassembly
1. Remove screws of console finisher assembly back side, and remove ashtray (front portion).
2. Remove rear upper console assembly.
3. Remove screws and remove cup holder assembly.
4. Remove screws and remove console front bracket.
5. Remove console mask.
6. Remove console lid mounting screws and remove console lid.
7. Remove metal clips and remove console rear finisher.
8. Remove console ashtray.
9. Remove screw and remove console ashtray bracket.
10. Remove console pocket from center console assembly.
11. Remove auxiliary input jacks and socket knob, cigarette lighter case.

Assembly
Assemble in the reverse order of disassembly.

DISASSEMBLY AND ASSEMBLY OF CENTER CONSOLE (M/T MODELS)

Disassembly
1. Remove screws of console finisher assembly back side, and remove ashtray (front portion).
2. Remove coin pocket.
3. Remove console mask.
4. Remove console lid mounting screws and remove console lid.
5. Remove metal clips and remove console rear finisher.
6. Remove console ashtray.
7. Remove screw and remove console ashtray bracket.
8. Remove screws and remove cup holder assembly.
9. Remove auxiliary input jacks and socket knob, cigarette lighter case.
10. Remove console sub harness.

Assembly
Assemble in the reverse order of disassembly.