Front Door Panel: Service and Repair

DOOR FINISHER

Exploded View

INT-11 Exploded View:

Removal and Installation

REMOVAL
1. Fully open door window.




2. Remove inside handle escutcheon (1) with remover tool (A).




3. Remove screw (A), located on the back side of inside handle escutcheon.




4. Remove armrest cap (1) with remover tool (A).




5. Remove screws (A), located on the back side of power window finisher.




6. Remove step lamp (1).




7. Insert a remover tool (A) into clips on door finisher (1), and disengage clips.

CAUTION: Insert a remover tool (A) into the part shown by the arrow (between the clips and the body side panel).




8. Pull up door finisher and pull out toward vehicle inside.
- Disconnect seat memory switch connector (A) (with ADP).
- Disconnect tweeter connector (B) (with BASE AUDIO).
- Disconnect door squawker connector (B) (with BOSE AUDIO).




9. Disconnect lock knob cable (1) and inside handle cable (2) from door inside handle assembly.
10. Disconnect power window switch connector and mirror control switch connector.
11. Remove door finisher.
12. Remove the following parts after removing door finisher.
- Door inside handle assembly.
- Seat memory switch (with ADP).
- Tweeter (with BASE AUDIO).
- Door squawker (with BOSE AUDIO).

INSTALLATION
Install in the reverse order of removal.

CAUTION: When installing door finisher, check that clips are securely fitted in panel holes on body, and then press them in.