System Specifications

Exploded View EM-202 (Part 1):

Exploded View EM-202 (Part 2):

Timing Chain Tensioner

Crankshaft Pulley
Install crankshaft pulley as follows:
Fix crankshaft with ring gear stopper [SST: J-45476].
Install crankshaft pulley, taking care not to damage front oil seal.
Install according to dowel pin of oil pump drive spacer.
Lightly tapping its center with plastic hammer, insert pulley.

CAUTION: Do not tap pulley on the side surface where belt is installed (outer circumference).

Apply engine oil onto threaded parts of crankshaft pulley bolt and seating area.
Tighten crankshaft pulley bolt.
Torque 93.1 Nm (9.5 kg-m, 69 ft-lb)
Put a paint mark on crankshaft pulley aligning with angle mark on crankshaft pulley bolt.





Further tighten by 90 degrees. (Angle tightening)
Check the tightening angle by referencing to the notches. The angle between two notches is 90°.

Timing Cover

Exploded View EM-202 (Part 1):

Exploded View EM-202 (Part 2):

Tighten mounting bolts in numerical order as shown in the figure.





There are four type mounting bolts.
After all mounting bolts are tightened, retighten them in numerical order as shown in the figure.

CAUTION: Be sure to wipe off any excessive liquid gasket leaking onto surface mating with oil pan.