Crankshaft Pulley
Crankshaft PulleyInstall crankshaft pulley as follows:
Fix crankshaft with ring gear stopper [SST: J-45476].
Install crankshaft pulley, taking care not to damage front oil seal.
Install according to dowel pin of oil pump drive spacer.
Lightly tapping its center with plastic hammer, insert pulley.
CAUTION: Do not tap pulley on the side surface where belt is installed (outer circumference).
Apply engine oil onto threaded parts of crankshaft pulley bolt and seating area.
Tighten crankshaft pulley bolt.
Torque 93.1 Nm (9.5 kg-m, 69 ft-lb)
Put a paint mark on crankshaft pulley aligning with angle mark on crankshaft pulley bolt.
Further tighten by 90 degrees. (Angle tightening)
Check the tightening angle by referencing to the notches. The angle between two notches is 90°.