Removal and Installation of Instrument Panel & Pad

INSTRUMENT PANEL ASSEMBLY

Exploded View IP-10 (Part 1):

Exploded View IP10 (Part 2):

Component Parts Drawing

Removal and Installation of Instrument Panel & Pad

REMOVAL




1. Remove cup holder.
- Backside pull up.

2. Remove switch finisher.
- Disconnect harness connector.




3. Remove A/T console finisher.
- Place the selector lever in "D" position.
- Remove selector lever knob.
- Lift up backside and pull back.
- Disconnect harness connector.




4. Remove cluster lid C.
- Pull back.
- Disconnect harness connector.




5. Remove console rear finisher.
- Insert a remover into upper space of console rear finisher.

6. Remove center console with power tool.
- Disconnect harness connector.




7. Remove glove box.
- Remove damper pin to left side.

8. Remove instrument passenger lower cover.
- Disconnect harness connector.

9. Remove instrument side finisher (RH).
- Insert a remover into lower space.

10. Remove glove box cover with power tool.




11. Remove instrument finisher B.
- Insert a remover into right space.




12. Remove instrument side finisher (LH).
- Insert a remover into lower space.




13. Remove instrument driver lower panel.
- Remove hood opener mounting bolt.
- Pull back.
- Disconnect harness connector.




14. Remove instrument finisher A.
- Insert a remover into upper space.




15. Remove instrument finisher C.
- Insert a remover into upper space




16. Remove cluster lid A
- Pull back.

17. Remove combination meter.
18. Remove steering column cover with power tool.
19. Remove upper ventilator grille.




20. Remove center ventilator grille.
- Insert a remover into rear lower space.
- Pull up.

21. Remove multifunction switch.
22. Remove front display unit.
23. Remove audio assembly.
24. Remove NAVI C/U.




25. Remove side ventilator grille (RH/LH).
- Insert a remover into lower space.
- Pull back.




26. Remove front defroster grille.
- Insert a remover into back space.
- Disconnect harness connector.

27. Remove instrument panel & pad.
- Remove front passenger air bag module mounting bolt and disconnect harness connector.
- Remove front pillar garnish.

INSTALLATION
Install in the reverse order of removal.

CAUTION: To install, confirm locating pins on back of instrument panel are completely inserted into holes on vehicle. Do not leave harness stuck when installing.