Crankshaft Pulley

Crankshaft Pulley
Install crankshaft pulley as follows:
Fix crankshaft using the ring gear stopper [SST: KV10117700 (J44716)].
Install crankshaft pulley, taking care not to damage front oil seal.
When press-fitting crankshaft pulley with plastic hammer, tap on its center portion (not circumference).
Tighten crankshaft pulley bolt.
Torque 44.1 Nm (4.5 kg-m, 33 ft-lb)





Place a paint mark (A) on crankshaft pulley (1) aligning with the angle mark (B) on crankshaft pulley bolt (2). Tighten the bolt 90 degrees (Angle tightening).
Rotate crankshaft pulley in normal direction (clockwise when viewed from front) to confirm it turns smoothly.