Diagnostic Procedure 5
DIAGNOSTIC PROCEDURE 5Inspecting SRS intermittent malfunction by using CONSULT-II - Diagnosis mode
Refer to GI-38, "CONSULT-II Start Procedure". Testing and Inspection
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.
1. Touch "SELF-DIAG [PAST]".
2. If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 5.
a. If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".
3. Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.
4. Diagnostic code is displayed on "TROUBLE DIAG RECORD".
5. Touch "PRINT".
6. Compare diagnostic codes to "DTC No. Index ("SELFDIAG [PAST]" or "TROUBLE DIAG RECORD")".
7. Touch "BACK" key of CONSULT-II until "SELECT SYSTEM" appears.
8. Turn ignition switch OFF, then turn off and disconnect CONSULT-II, and both battery cables.
9. Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnosis result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.
10. Go to SRS-27, "DIAGNOSTIC PROCEDURE 3" , for final checking. Diagnostic Procedure 3
DTC No. Index ("Self-Diag [Past]" Or "Trouble Diag Record") (Part 1):
DTC No. Index ("Self-Diag [Past]" Or "Trouble Diag Record") (Part 2):
DTC No. Index ("Self-Diag [Past]" Or "Trouble Diag Record") (Part 3):
DTC No. Index ("Self-Diag [Past]" Or "Trouble Diag Record") (Part 4):
DTC No. Index ("Self-Diag [Past]" Or "Trouble Diag Record") (Part 5):
DTC No. Index ("SELF-DIAG [PAST]" or "TROUBLE DIAG RECORD")