Compressor HVAC: Service and Repair

Removal and Installation of Compressor

REMOVAL

Exploded View ATC-153:

VQ35DE
1. Use a refrigerant collecting equipment (for HFC-134a) to discharge the refrigerant.
2. Remove air cleaner case and air duct. Refer to "AIR CLEANER AND AIR DUCT".
3. Remove engine undercover, using power tools.




4. Remove mounting nuts from low-pressure flexible hose and high-pressure flexible hose.

CAUTION: Cap or wrap the joint of low-pressure flexible hose and high-pressure flexible hose with suitable material such as vinyl tape to avoid the entry of air.

5. Disconnect compressor (magnet clutch and ECV) connectors.
6. Remove A/C compressor belt. Refer to "DRIVE BELTS".




7. Remove mounting bolts, and then remove damper bracket.




8. Remove mounting bolts from compressor, using power tools.
9. Remove compressor downward of the vehicle.

INSTALLATION
Installation is basically the reverse order of removal.

CAUTION:
- Replace O-rings of low-pressure flexible hose, low-pressure pipe (VK45DE) and high-pressure flexible hose with new ones, and then apply compressor oil to it when installing it.
- When recharging refrigerant, check for leaks.




Check Disc to Pulley Clearance
Check clearance around entire periphery of clutch disc.

Disc to pulley clearance: 0.3 - 0.6 mm (0.012 - 0.024 in)

If specified clearance is not obtained, replace compressor.