Crash Zone Sensor

CRASH ZONE SENSOR

Removal and Installation

REMOVAL

CAUTION:
- Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes.
- Do not use air tools or electric tools for servicing.




1. Remove crash zone sensor connector.
2. Remove crash zone sensor fixing nuts.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check crash zone sensor for proper installation.
- After the work is complete, perform self-diagnosis to make sure that no malfunction is detected. Refer to SRS-20, "SRS Operation Check". SRS Operation Check