Hood Latch Release Cable: Service and Repair

Removal and Installation of Hood Lock Control

Exploded View BL-16:

REMOVAL
1. Remove the front grill.
2. Remove the fender protector (front and rear). Refer to "FENDER PROTECTOR".




3. Remove the hood lock assembly.
4. Remove the instrument lower driver panel. Refer to "(J) Instrument Driver Lower Panel".




5. Disconnect the hood lock cable from the hood lock, and clip it from the radiator core upper support and hood ledge.
6. Remove the mounting screws, and remove the hood opener.
7. Remove the grommet on the panel, and pull the hood lock cable toward the passenger compartment.

CAUTION: While pulling, be careful not to damage (peeling) the outside of the hood lock cable.

INSTALLATION
1. Pull the hood lock cable through the panel hole to the engine compartment.






CAUTION: Be careful not to bend the cable too much, keeping the radius 100 mm (3.94 in) or more.

2. Make sure that the cable is not offset from the positioning grommet, and push the grommet into the panel hole securely.
3. Apply the sealant to the grommet (at * mark) properly.




4. Install the cable securely to the lock.
5. After installing, Make sure the hood lock adjustment and hood opener operation.