Closed Throttle Position and WOT Position Circuit
CLOSED THROTTLE POSITION AND WIDE OPEN THROTTLE POSITION CIRCUITCONSULT-II Reference Value:
Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to "SELF-DIAGNOSTIC RESULT MODE". Self-Diagnostic Result Mode
Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line.
NO >> GO TO 2.
2. CHECK THROTTLE POSITION SIGNAL CIRCUIT
With CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "A/T" with CONSULT-II.
3. Depress accelerator pedal and read out the value of "CLSD THL POS" and "W/O THL POS".
OK or NG
OK >> INSPECTION END
NG >> Check the following. If NG, repair or replace damaged parts.
^ Perform the self-diagnosis for "ENGINE" with CONSULT-II. Refer to EC-137, "SELF-DIAG RESULTS MODE" (for VQ35DE engine). Self-Diag Results Mode
Refer to EC-849, "SELF-DIAG RESULTS MODE" (for VK45DE engine). Self-Diag Results Mode
^ Open circuit or short to ground or short to power in harness or connectors. Pin terminals for damage or loose connection with harness connector.