Work Support

OPERATION PROCEDURE
1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)" "AIR PRESSURE MONITOR" "WORK SUPPORT".
^ If "AIR PRESSURE MONITOR" is not displayed, print the "SELECT SYSTEM" screen.

NOTE: Just after starting engine, or turning ignition switch ON, it may not be displayed even if "START (NISSAN BASED VHCL)" is touched. In this case, reconnect CONSULT-II and CONSULT-II CONVERTER.

5. Perform the "ID Regist". Refer to "ID Registration Procedure". Transmitter ID Registration Procedure