Electronic Throttle Actuator: Service and Repair
ELECTRIC THROTTLE CONTROL ACTUATORREMOVAL
Components:
1. Remove electric throttle control actuator as follows:
a. Disconnect harness connector.
b. Loosen mounting bolts in reverse order as shown in the figure.
CAUTION:
^ Handle carefully to avoid any shock to electric throttle control actuator.
^ Do not disassemble.
INSTALLATION
Electric Throttle Control Actuator
^ Install gasket with positioning no-protrusion surface upward or downward.
^ Tighten in numerical order as shown in the figure.
^ Perform the Throttle Valve Closed Position Learning when harness connector of electric throttle control actuator is disconnected. Refer to EC-95, Throttle Valve Closed Position Learning.Throttle Valve Closed Position Learning
^ Perform the Idle Air Volume Learning and Throttle Valve Closed Position Learning when electric throttle control actuator is replaced.
Refer to EC-96, Idle Air Volume Learning. Programming and Relearning
Refer to EC-95, Throttle Valve Closed Position Learning. Throttle Valve Closed Position Learning