CONSULT-II Basic Operation

CONSULT-II BASIC OPERATION

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.




1. With the ignition switch OFF, connect "CONSULT-II" and "CONSULT-II CONVERTER" to the data link connector, and then turn ignition switch ON.




2. Touch "START (NISSAN BASED VHCL)".




3. Touch "ADAPTIVE LIGHT" on "SELECT SYSTEM" screen.
If "ADAPTIVE LIGHT" is not indicated, check power supply and ground of AFS control unit. If it is normal, refer to "CONSULT-II Data Link Connector (DLC) Circuit" in "GI section".




4. Select the desired part to be diagnosed on the" SELECT DIAG MODE" screen.