Rear Shelf: Service and Repair

REAR PARCEL SHELF FINISHER




Removal and Installation

REMOVAL
1. Remove rear seatback and rear seat cushion.
2. Remove rear seat belt floor anchor bolt and rear seat belt shoulder anchor bolt.
3. Disengage child anchor cover front pawls, and then pull out child anchor cover (LH/RH center) toward front of vehicle.(Models with rear window sunshade)
4. Remove rear kicking plate inner, rear wheelhouse garnish, rear pillar finisher. Refer to "BODY SIDE TRIM".
5. Disconnect high-mounted stop lamp harness connector from front side of rear parcel shelf finisher. (Models with rear window sunshade)




6. Remove rear parcel shelf finisher mounting clip using a clip clamp remover.
7. Remove the following parts after removing rear parcel shelf finisher.
- Rear speaker grille (for woofer)
- High-mounted stop lamp

INSTALLATION
Install in the reverse order of removal.

CAUTION: Make sure that clips are securely fitted in panel holes on body when installing, and then press them in.

Rear Window Sunshade

REMOVAL AND INSTALLATION

CAUTION: Be careful not to damage the rear window glass.

Removal
1. Remove rear parcel shelf finisher.
2. Disconnect rear window sunshade harness connector.
3. Remove rear window sunshade mounting bolts.
4. Lift up rear window sunshade and pull out locating pin from body side panel hole, and then remove rear window sunshade.

Installation
Install in the reverse order of removal.