Cowl: Service and Repair

COWL TOP




Removal and Installation

REMOVAL
1. Remove front wiper arm (LH/RH) from vehicle. Refer to "Removal and Installation of Front Wiper Arms, Adjustment of Wiper Arms Stop Location".
2. Remove engine room cover (LH/RH), battery cover and brake master cylinder cover.
3. Remove cowl top seal rubber.
4. Remove clips of cowl top cover (LH/RH).




5. Plastic pawl A is removed and cowl top cover RH (2) ahead of vehicles.
6. Lever B is pushed and cowl top cover LH (1) is removed ahead of vehicles.

INSTALLATION
Note the following, and install in the reverse order of removal.




- Install cowl top cover LH (1) with C (pin from front windshield glass) aligned with concave part.




- Slide the pin while aligning with the concave part of E. Engage the joint of plastic pawls of A with D. And then assemble cowl top covers LH (1) and RH (2).

CAUTION: After installing, perform adjustment of wiper arm. Refer to "Removal and Installation of Front Wiper Arms, Adjustment of Wiper Arms Stop Location".