Backup Lamp: Service and Repair

BACK-UP LAMP




Removal and Installation

REMOVAL
1. Remove trunk lid finisher inner.
2. Disconnect back up lamp and trunk lid request switch connector.
3. Remove trunk lid finisher outer.
4. Remove screws (2) and clip, and then remove back up lamp.
5. Remove seal packing from back up lamp.

INSTALLATION
Installation is the reverse order of removal.

Back up lamp mounting nut Torque: 3.0 N-m (0.31 kg-m, 27 in-lb)
Trunk lid finisher mounting nut Torque: 3.0 N-m (0.31 kg-m, 27 in-lb)

Install a new seal packing to the back up lamp.

CAUTION: Seal packing cannot be reused.