Removal and Replacement

REAR DOOR GLASS AND REGULATOR




Removal and Installation

DOOR GLASS

Removal
1. Remove the rear door finisher.
2. Remove the rear door out side molding.
3. Remove the rear door speaker.
4. Remove the sealing screen.




5. Operate the power window switch to raise/lower the door window until the glass mounting bolts can be seen.




6. Remove a part of the rear door weatherstrip.
7. Remove the partition sash mounting bolts (lower) and screw (upper) to remove the sash.
8. Remove the glass mounting bolts, and remove the door glass.




9. Remove the partition glass from the panel.

Installation
Install in the reverse order of removal.

REGULATOR ASSEMBLY

Removal
1. Remove the rear door finisher.
2. Remove the rear door out side molding.
3. Remove the rear door speaker.
4. Remove the sealing screen.




5. Operate the power window switch to raise/lower the door window until the glass mounting bolts can be seen.




6. Raise up the door glass and hold with a suction lifter.




7. Remove the power window motor mounting bolts, and remove the regulator from the panel.
8. Disconnect the connector for the regulator assembly.

Installation

Install in the reverse order of removal.




Inspection after removal
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Gear wear
- Regulator deformation
- Spring damage
- Grease condition for each sliding part

The arrows in the figure show the application points of the grease "Dow Corning Moly Coat SK623" or equivalent.