Seals and Gaskets: Service and Repair

REAR OIL SEAL

Removal and Installation
REMOVAL
1. Remove propeller shaft.





2. Remove rear oil seal using oil seal puller.
Tool number: KV381054S0 ( - )

INSTALLATION





1. Apply multi-purpose grease to rear oil seal lip. Drive in rear oil seal until the edge is approximately 1.2 - 2.2 mm (0.047 - 0.087 inch) above the boss edge using drift.
Tool number: ST33400001 (J-26082)

CAUTION:
^ Do not reuse rear oil seal.
^ When installing, do not tilt oil seal.

2. Install propeller shaft.

CAUTION:
^ If lubricant leak has occurred during the repair work, check oil level after finishing work.