Shift Interlock Cable: Service and Repair

KEY INTERLOCK CABLE





CAUTION:
^ Install key interlock cable in such a way that it will not be damaged by sharp bends, twists or interference with adjacent parts.
^ After installing key interlock cable to control device, make sure that casing cap and bracket are firmly secured in their positions. If casing cap can be removed with an external load of less than 39 N (4.0 kg, 8.8 lb), replace key interlock cable with new one.

Removal and Installation
REMOVAL





1. Unlock slider by squeezing lock tabs on slider from adjuster holder.
2. Remove casing cap from bracket of control device assembly and remove interlock rod from interlock cable.





3. Remove holder from key cylinder and remove key interlock cable.

INSTALLATION





1. Set key interlock cable to key cylinder and install holder.
2. Clamp cable and fix to control cable with band.
3. Turn ignition key to lock position.
4. Set selector lever to P position.





5. Insert interlock rod into adjuster holder.
6. Install casing cap to bracket.
7. Move slider in order to fix adjuster holder to interlock rod.

CAUTION:
Do not touch any adjacent parts of key interlock cable when slider is being held.
Insert slider into key interlock rod straightly.