Rear Door Lock

REAR DOOR LOCK




Component Structure

INSPECTION AND ADJUSTMENT
Remove the rear door finisher.

Removal and Installation

REMOVAL
1. Remove the rear door finisher. Refer to "Removal and Installation".




2. After gaining access to the inside handle on the back side of the rear door finisher, disconnect the inside handle cable and lock knob cable.




3. Remove the mounting bolts (TORX T30), remove the door lock assembly.
4. Disconnect the door lock actuator connector.




5. Remove the outside handle mounting bolts, and move the handle backward to disengage it from the panel in front of the outside handle escutcheon, then remove the handle.

INSTALLATION
Install in the reverse order of removal.

CAUTION: To install each rod, be sure to rotate the rod holder until a click is felt.