Confirmation/Adjustment Mode

Confirmation/Adjustment Mode




1. Start the diagnosis function, and then select "Confirmation/Adjustment".




2. Select each screen switch of Confirmation/Adjustment screen to display the relevant diagnosis screen. Press the "BACK" switch to return to the initial screen of Confirmation/Adjustment.




DISPLAY DIAGNOSIS
If RGB signal is malfunctioning, the tint of the color bar display is as follows.

R (red) signal error : Light blue (Cyan) tint
G (green) signal error : Purple (Magenta) tint
B (blue) signal error : Yellow tint




VEHICLE SIGNALS
A comparison check can be made of each actual vehicle signal and
the signals recognized by the system.

NAVIGATION




Steering Angle Adjustment
The steering angle output value detected with the gyroscope can be adjusted.




Speed Calibration
Usually the automatic distance correction function adjusts the deviation in distance caused by the tires wearing down or the tire pressure change. If prompt adjustment is necessary when the tire chains are installed etc., perform this procedure.

ERROR HISTORY
The results of "Self-diagnosis" indicate only malfunctions detected during the current "Self-diagnosis".

If an error occurred before the ignition switch was turned ON, and does not occur again until "Self-diagnosis" is completed, the diagnosis result is judged normal. Therefore, errors in the past which cannot be found by "Self-diagnosis", must be found by checking the "Error record".

The error history shows the error occurrence frequency in the past. The frequency of occurrence is displayed by 2 types: the count down type and the count up type. The type is predetermined according to the error item.

In "Error History", time and place that the selected error last occurred are displayed. Be careful about the following.
- If there is a malfunction with the GPS antenna circuit board in the NAVI control unit, the correct date of occurrence may not be displayed.
- Place of the error occurrence is represented by the position of the current-location mark at the time an error occurred. If current-location mark has deviated from the correct position, then the place of the error occurrence cannot be located correctly.




Transition Screen

Count Up Type
- At the time the ignition switch is turned ON if the error is detected, the counter increases by 1. If it is normal when the ignition switch is turned ON, the counter remains the same.
- The upper limit of the counter is 50. 51 or more is displayed as 50. It can be reset to 0 by "Delete log" switch.

Part 1:

Part 2:

Error Item
Some error items may be displayed simultaneously according to the cause. If some error items are displayed simultaneously, the detection of the cause can be performed by analyzing the combination of display items




DELETE UNIT CONNECTION LOG
The connection history of unit and error history that is recorded in NAVI control unit can be erased, the connection history of the removed unit can be cleared.