Brake Signal Circuit

BRAKE SIGNAL CIRCUIT





CONSULT-II Reference Value

Diagnostic Procedure
1. CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to SELF-DIAGNOSTIC RESULT MODE, With Manufacturer's Scan Tool and Without Scan Tool.
Is a malfunction in the CAN communication indicated in the results?
YES >> Check CAN communication line. Refer to DTC U1000 CAN COMMUNICATION LINE.
NO >> GO TO 2.

2. CHECK STOP LAMP SWITCH CIRCUIT
With CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)
2. Select ECU INPUT SIGNALS in DATA MONITOR mode for A/T with CONSULT-II.








3. Read out ON/OFF switching action of the BRAKE SW.
OK or NG
OK >> INSPECTION END
NG >> GO TO 3.

3. CHECK STOP LAMP SWITCH








Check continuity between stop lamp switch harness connector E124 terminals 1 and 2. Refer to Wiring Diagram.
Check stop lamp switch after adjusting brake pedal, refer to BRAKE PEDAL.
OK or NG
OK >> INSPECTION END
NG >> Check the following. If NG, repair or replace damaged parts.
^ Harness for short or open between battery and stop lamp switch.
^ Harness for short or open between stop lamp switch and combination meter.