Vehicle Immobilizer System

CONSULT-II

CONSULT-II INSPECTION PROCEDURE
1. Turn ignition switch OFF.




2. Insert IVIS (NATS) program card into CONSULT-II.

Program card: NATS (AEN02C)

3. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.




4. Turn ignition switch ON.
5. Touch "START".




6. Touch "OTHER".




7. Select "NATS V.5.0".
If "NATS V5.0" is not indicated, go to GI-38, "CONSULT-II Data Link Connector (DLC) Circuit". Data Link Connector Schematic




8. Perform each diagnostic test mode according to each service procedure.

For further information, see the CONSULT-II Operation Manual
NATS-IVIS/NVIS.