Removal and Installation

FRONT DOOR GLASS AND REGULATOR

Removal and Installation




REMOVAL
1. Remove the front door finisher.
2. Remove the door speaker.




3. Operate the power window main switch to raise/lower the door window until the glass mounting bolts can be seen.
4. Remove the glass mounting bolts.




5. While holding the door window, raise it at the rear end to pull the glass out of the sash toward the outside of the door.




6. Remove the mounting bolts, and remove the module assembly.
7. Disconnect the harness connector for the module assembly, and unclip the harness from the back.

INSTALLATION
Install in the reverse order of removal.

INSPECTION AFTER REMOVAL

Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
- Wire wear
- Regulator deformation
- Grease condition for each sliding part




The arrows in the figure show the application points of the body grease.

SETTING AFTER INSTALLATION

Setting of Limit Switch
If any of the following work has been done, set the limit switch (integrated in the motor).
- Removal and installation of the regulator.
- Removal and installation of the motor from the regulator.
- Operate the regulators as a unit.
- Removal and installation of the glass.
- Removal and installation of the glass run.

Resetting
After installing each component to the vehicle, follow the steps below.

1. Raise the glass to the top position.




2. While pressing and holding the reset switch, lower the glass to the bottom position.
3. Release the reset switch, and check the reset switch returns to the original position, and then raise the glass to the top position.

CAUTION: Do not operate the glass automatically to raise the glass to the top position.