AWD Actuator Relay

AWD Actuator Relay
CONSULT II REFERENCE VALUE IN DATA MONITOR MODE





Data are reference value.

DIAGNOSTIC PROCEDURE
^ Check the following if 4WD ACTUATOR RLY [C1205] is displayed in self-diagnostic results of CONSULT-II.

1. CHECK AWD SOLENOID SYSTEM
Perform self diagnosis. Refer to SELF-DIAG RESULT MODE.
Is the 4WD SOLENOID [C1204] displayed?
YES >> Perform trouble diagnosis for AWD solenoid. AWD Solenoid
NO >> GO TO 2.

2. CHECK AWD ACTUATOR RELAY SIGNAL
With CONSULT-II
1. Turn ignition switch ON. (Do not start engine.)








2. Select DATA MONITOR mode for ALL MODE AWD/4WD with CONSULT-II.
3. Start engine and read out ON/OFF signal of ETS ACTUATOR.
OK or NG
OK >> GO TO 4.
NG >> GO TO 3.

3. CHECK AWD CONTROL UNIT
Check AWD control unit input/output signal. Refer to AWD Control Unit Input/Output Signal Reference Values.
OK or NG
OK >> GO TO 4.
NG >> Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.

4. CHECK DTC
Perform the self diagnosis, after driving a vehicle for a while.
OK or NG
OK >> INSPECTION END
NG >> Replace AWD control unit.