Front Suspension

On-Vehicle Inspection and Service
Make sure the mounting conditions (looseness, back lash) of each component and component statues (wear, damage) are normal.

INSPECTION OF TRANSVERSE LINK BALL JOINT END PLAY
1. Set front wheels in a straight-ahead position. Do not depress brake pedal.
2. Check ball joint axial end play of each link.

CAUTION: Be careful not to damage ball joint boot.

Upper Link Ball Joint





Measure axial end play by installing and moving up/down with an iron pry bar or something similar between upper link and steering knuckle.
Standard value
Axial end play : 0 mm (0 inch)

Steering Knuckle Lower Ball Joint





Measure axial end play by installing and moving up/down with an iron pry bar or something similar between steering knuckle and wheel.
Standard value
Axial end play : 0 mm (0 inch)

Compression Rod Ball Joint





Measure axial end play by installing and moving up/down with an iron pry bar or something similar between compression rod and transverse link.
Standard value
Axial end play : 0 mm (0 inch)

SHOCK ABSORBER INSPECTION
Check shock absorber for oil leakage, damage and replace if necessary.