Crash Zone Sensor

Removal and Installation

REMOVAL

CAUTION:
- Before servicing SRS, turn ignition switch OFF, disconnect both battery cables and wait at least minutes.

1. Remove front grille.




2. Remove crash zone sensor connector.
3. Remove crash zone sensor fixing nuts.

CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not disassemble crash zone sensor.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Check crash zone sensor for proper installation.
- After the work is complete, perform self-diagnosis to make sure no malfunction is detected. Refer to "SRS Operation Check" .