Diagnostic Procedure 2

1. Turn ignition switch OFF.




2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.




3. Turn ignition switch ON.
4. Touch "START (NISSAN BASED VHCL)".




5. Touch "AIR BAG".
If "AIR BAG" is not indicated, refer to "CONSULT-II Data Link Connector (DLC) Circuit". Diagnostic Aids




6. Touch "SELF-DIAG [CURRENT]".




7. Diagnostic code is displayed on "SELF-DIAG [CURRENT]".




If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check", check the battery voltage. If the battery voltage is less than 9 V, charge or replace the battery. Then go to "DIAGNOSTIC PROCEDURE 3". If the battery voltage is OK, go to "DIAGNOSTIC PROCEDURE 4 (CONTINUED FROM DIAGNOSTIC PROCEDURE 2)" to diagnose the following cases:

- Self-diagnosis result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
- The SRS system malfunctions intermittently.










CONSULT-II Diagnostic Code Chart ("SELF-DIAG [CURRENT]")

NOTE:
- Follow the procedures in numerical order when repairing malfunctioning parts. Confirm whether malfunction is eliminated using air bag warning lamp or CONSULT-II each time repair is finished. If malfunction is still observed, proceed to the next step. When malfunction is eliminated, further repair work is not required.