Accelerator Pedal: Service and Repair

ACCELERATOR CONTROL SYSTEM






REMOVAL
1. Remove accelerator pedal position sensor harness connector.
2. Loosen nuts, and remove accelerator pedal assembly.

CAUTION:
- Do not disassemble the accelerator pedal assembly. Do not remove the sensors from the assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep the assembly away from water.

INSTALLATION
Install in the reverse order of removal.

INSPECTION AFTER INSTALLATION
- Check that the accelerator pedal moves smoothly within the whole operation range.
- Check that the accelerator pedal securely returns to the original position.
- For the electrical inspection of the accelerator pedal assembly, refer to "DTC P0226 APP SENSOR".

CAUTION: When the harness connector of the accelerator pedal position sensor is disconnected, perform "Accelerator Pedal Released Position Learning". Refer to "Accelerator Pedal Released Position Learning". Programming and Relearning