Fuel Pump Control Unit: Testing and Inspection
With Consult1. Start engine and let it idle.
2. Perform "FPCM" in "ACTIVE TEST" mode with CONSULT-II.
3. Check the following.
- When selecting "HI", "FPCM DR VOLT" indicates approximately 0 V.
- When selecting "LOW", "FPCM DR VOLT" indicates approximately 4.4 V.
4. If NG, replace FPCM.
OR
Without Consult
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch "OFF" and wait at least 5 seconds.
3. Start engine and let it idle.
4. Check voltage between terminals (1) and (2).
Within 30 seconds of starling engine:
Approximately 0 V
More than 30 seconds after starting engine:
Approximately 4.4 V
5. If NG, replace FPCM.